Indenting BEGIN CASE, CASE, END CASE

Gerry · Nov 18, 2005#12005-11-18T07:35+00:00

Hi all,

I'm trying to setup my wordfile to indent the following codes but I can't find the right settings.

From this:

BEGIN CASE
CASE X=1
CALL SOMETHING1
CASE X=2
CALL SOMETHING2
END CASE

To this:

Code: Select all

BEGIN CASE
    CASE X=1
        CALL SOMETHING1
    CASE X=2
        CALL SOMETHING2
END CASE

Now if I reindent this code using the following settings:

Code: Select all

/Indent Strings = "BEGIN" "CASE"
/Unindent Strings = "END" "END CASE"

I get the following:

Code: Select all

BEGIN CASE
   CASE X=1
   CALL SOMETHING1
   CASE X=2
   CALL SOMETHING2
END CASE

Please advise. Many thanks.

Mofi · May 27, 2006#22006-05-27T12:56+00:00

There is no really working solution for this problem. The same problem also exists for the switch statement in 'C'. I think the best solution is to use

/Indent Strings = "BEGIN" "CASE"
/Unindent Strings = "END" "CASE"

and add after BEGIN CASE manually an extra indent with tab key and remove 1 indent also manually before writing END CASE. You should use a template or macro for creating the BEGIN/END CASE block with 2 CASE for writing the code faster.